crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0chasecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 chase

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use the Screwdriver J000 Phillips Head to remove 6 of the external screws along the outside edge of the camera.
-[* black] Use the Screwdriver J000 Phillips Head to remove the 2 screws located on the bottom edge of the peephole cover.
-[* black] Carefully remove the peephole cover with your hands.
-[* black] Use the Screwdriver J000 Phillips Head to remove the 2 screws located near the top edge of the face of the peephole glass.
+[* black] Remove the four 4.6mm Phillips screws from the sides and two 3.2mm Phillips screws along the bottom.
+[* black] Remove the two 3.2mm Phillips screws located on the bottom edge of the viewfinder cover.
+[* black] Carefully remove the viewfinder cover with your hands.
+[* black] Remove the two 4.4mm J000 Phillips screws located near the top edge of the viewfinder.
[* black] Slide the Wide Plastic Opening Tool along the underside of the rear casing as you gently pull upwards.
- [* black] Take care not to disconnect the filament connections as reinserting them can prove to be difficult. Slowly lower the casing to allow access to the peephole.
+ [* icon_note] Be careful not to disconnect the filament connections. Reinserting them can be difficult.
+[* black] Slowly lower the casing to allow access to the viewfinder.