crwdns2933803:08crwdne2933803:0
crwdns2933797:0Mani Jaishankercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mani Jaishanker
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] ***Remove the LED Light*** |
|---|---|
| + | [* black] The LED is connected to a pin at the end of one of the wires connected to the circuit board. |
| + | [* black] Upon close inspection, you can see that the LED's two ends are bend(in the red square of the second image) to prevent it from slipping of off the pin. |
| + | [* black] Use a blunt tweezers to bend and straighten the two ends. |
| + | [* black] Once the two ends are straight, gently pull the LED out of the pin. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0