crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:017crwdne2933803:0

crwdns2933797:0Taylor Arnicarcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Remove two 7 mm Phillips screws securing the DC-in board to the upper case.
-[* black] Note, this step is not completely necessary. It will make disconnecting the cable connected to the DC-in board easier, but if you have difficulty removing the screws don't bother.
+[* icon_note] Note: This step is not completely necessary, but it will make it easier to disconnect the cable that is connected to the DC-in board.