crwdns2933803:03crwdne2933803:0
crwdns2933797:0Delanie Burgesscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Delanie Burgess
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Take the Torx T5 Screwdriver and carefully remove all the screws in the Droid Maxx’s motherboard. Note that there is a total of eight (8) black screws spread across the motherboard: four (4) at the top and four (4) at the bottom. There are also two (2) silver screws located on the right edge/side, one at the bottom and one about at the middle. |
|---|---|
| - | [* black] Remove the single screw securing the camera housing. This may be a T3 (Ultra) or T4 (MAXX) screw so use the appropriate driver. |
| - | [* black] Locate two (2) tabs in the upper plastic cover that surrounds the camera, one at each corner of the Droid Maxx |
| - | [* black] Take a plastic prying tool and gently lift both tabs to release the cover. Be careful because these plastic tabs are very delicate and can break easily. |
| + | [* black] Using the Torx T5 Screwdriver, carefully remove all of the screws in the motherboard. |
| + | [* black] There are 8 black screws: 4 at the top and 4 at the bottom of the motherboard. |
| + | [* black] There are 2 silver screws on the side: 1 at the bottom and 1 in the middle. |
| + | [* black] Use either a T3 (Ultra) or T4 (MAXX) to remove the single screw securing the camera housing. |
| + | [* black] Using the plastic opening tool, gently lift the two tabs in the upper plastic cover that surrounds the camera to release the cover. |