crwdns2933803:01crwdne2933803:0
crwdns2933797:0Michael Sawyercrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 David Hodson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Remove the four 2.4 mm Phillips #00 screws attaching the LCD to the front glass panel. | |
| [* black] Rotate the top of the LCD 90 degrees away from the front glass panel as shown in the second picture. | |
| [* icon_caution] Rotate the LCD and front glass panel slowly so you don't damage the antenna on the bottom of the LCD. | |
| - | [* black] Separate the LCD and front glass panel. |
| + | [* black] Separate the LCD and front glass panel. This can be done with a heat gun or hair dryer. After about 45-60 seconds of heat, use the pry tool around the glass and inside the rubber barrier. The digitizer ribbon will slide out of the frame through a slot. |