crwdns2933805:0crwdne2933805:0
crwdns2933797:0Rebecca Nunezcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Rebecca Nunez
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Make sure the device is unplugged. |
|---|---|
| - | [* black] Place the heater face down so the back panel is facing upwards. |
| - | [* red] Use a 4-inch Phillips #2 screwdriver to remove the four 1.7mm screws from the back panel. To remove the screws, rotate the screwdriver counterclockwise. |
| + | [* black] Make sure the device is unplugged and place the heater face down so the back panel is facing upwards. |
| + | [* red] Use a 4-inch long Phillips #2 screwdriver to remove the four 1.7mm screws from the back panel. |
| + | [* black] Consider using a flashlight to look inside the openings of the four screws. |
| + | [* black] To remove the screws, rotate the screwdriver counterclockwise. |
| + | [* icon_caution] Make sure that you carefully align the screwdriver with the screws. Do not use excessive force to remove or tighten the screws. Use only a Phillips #2 to remove the screws. The screws are a little long, and it will take you a little while to take all four of them out. |
| + | [* black] As you unscrew the screws, occasionally turn the heater over and gently shake it to see if the screws will fall out. |
| [* black] The device will open like a book. Due to internal wire connections, the front and back panels of the device do not separate completely. | |
| + | [* icon_caution] Do not force the front and back panels apart without completely taking out all four screws. |