crwdns2933803:01crwdne2933803:0
crwdns2933797:0Elisabeth Garciacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Elisabeth Garcia
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Loosen the screws on either side of protective lens cover until the IR LED light board is only attached by its cable cords. |
|---|---|
| - | [* icon_note] The screws do not have to be completely removed from the protective lens cover, but they can be if you need to replace them. |
| - | [* icon_caution] Remember to switch from the Torx security screwdriver to the PH 1 (Phillips Head) screwdriver so you don't strip your screws. |
| + | [* black] Use the PH1 screwdriver to remove or loosen ***both *** 1 cm screws on either side of the inner protective lens cover. ***This will loosen both the cover and the IR LED lightboard.*** |
| + | [* icon_note] The cover and the lightboard are two separate pieces held in place by these two screws. The cover should be set aside first before continuing with the lightboard. |