crwdns2936039:0iPod Nano 1st Generation Battery Replacementcrwdnd2936039:04crwdne2936039:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Andrew Bookholtcrwdnd2933797:0Kho 24, 2009crwdne2933797:0

	[* icon_note] To aid in soldering the new battery, be sure the holes of the solder pads are clear of solder. This way, you can insert the new battery leads and solder them in place.
-	[* black] To open the solder holes, open a safety pin and push it against the solder blocking the hole. At the same time, heat the same solder pad from the other side of the logic board.
+	[* black] To open the solder holes, open a safety pin and push it against the solder blocking the hole. At the same time, heat the same solder pad from the other side of the logic board. Opening the holes completely will require repeating this procedure several times from alternating sides of the logic board.
+	[* icon_caution] These holes are extremely small, so the safety pin will probably be too large to pass all the way through. Do not force the pin through.
	[* icon_caution] Do not overheat the logic board. If the safety pin does not make it through on the first try, allow the logic board to cool down, then reheat the pad. Repeat this process until the safety pin is pushed all the way through the hole.