crwdns2933803:04crwdne2933803:0
crwdns2933797:0jenkiecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 jenkie
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Add Soft-Start circuit |
|---|---|
| + | [* black] Cut the black wire and insert the circuit Do not forget some large shrinking tube to cover the whole circuit later (not pictured) |
| + | [* black] Add a wire between the gray-wired connection tab and the resistor R1. Add some shrinking tube to the resistor to prevent short-circuits. |
| + | [* black] WARNING: Do not solder the wires when the connection tabs are in the plastic holder - the plastic will melt. Remove the contacts from the plastic before soldering |
| + | [* black] Shrink tube over the whole circuit. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0