crwdns2933803:02crwdne2933803:0
crwdns2933797:0Phillip Takahashicrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Use a crescent wrench, or other flat hard tool, to brace against the two prongs on the bottom of the plunger assembly. |
|---|---|
| + | [* black] Place a crescent wrench on the top portion of the plunger assembly. Hold this wrench steady while you turn the other wrench counter clockwise until the bottom unthreads. |
| + | [* black] Disassemble and reassemble the plunger in the order shown in the third picture. |
| + | [* icon_note] Observe the directions and shapes of the seals in the third picture and be sure that the proper seals are installed in your pump. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0