crwdns2933803:04crwdne2933803:0
crwdns2933797:0Dylan Treschlcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dylan Treschl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the PCB on the Back of the Drive | |
| [* black] Remove the four Phillips PH1 screws holding the PCB onto the back of the drive. | |
| - | [* black] Disconnect the ribbon cables still attached to the PCB, and then remove it from the drive. |
| + | [* black] Disconnect the three ribbon cables still attached to the PCB by pulling the tabs on the side of each ribbon cable "holder" towards you. |
| + | [* black] Pull off the PCB from the back of the hard drive and remove the protective foam sheet from the back of the board. |