crwdns2936039:0iMac Intel 17" UniMac Version 2 Screen Adapter Replacementcrwdnd2936039:04crwdne2936039:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0senordingdongcrwdnd2933797:0Sun 21, 2012crwdne2933797:0

	[* black] New screen assembly
	[* black] In your Unimac Version 2 kit, you will find 2 plastic spacers, one is much larger then the other. The thinner one will go on the "inverter side" of the screen, the other will go on the opposite side.
-	[* black] You will also ~~fine~~ 4 small black screws.
-	[* black] Use the small screws to attach the non inverter spacer as shown in the picture.It has slots to allow for height ~~ajustment~~, ~~not~~ matter how you mount it, its going to be close to centered, but later in the guide we will get it perfect. Attach the metal bracket to the spacer with the torx screws as shown.
+	[* black] You will also find 4 small black screws.
+	[* black] Use the small screws to attach the non inverter spacer as shown in the picture.It has slots to allow for height adjustment, no matter how you mount it, its going to be close to centered, but later in the guide we will get it perfect. Attach the metal bracket to the spacer with the torx screws as shown.
	[* black] Take the inverter (metal) bracket, and remove the inverter. It is held in with some adhesive and should come out easily, just dont break it.
	[* black] Attach the thinner plastic spacer as shown.
	[* black] Slide the metal bracket in place, and secure the spacer as shown.
	[* black] Install the inverter as it was before, be sure to run the cable as shown.