crwdns2933803:026crwdne2933803:0
crwdns2933797:0Chayton Rittercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Chayton Ritter
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Apply a small bead of flux onto each solder pad. |
|---|---|
| + | [* icon_note] If you're using solder paste, apply a small amount of paste instead. Most solder pastes contain flux. |
| + | [* black] Use tweezers and picks to carefully maneuver your component so that it straddles between the solder pads. |
| + | [* icon_note] This can be very tricky depending on the size of your component! Take your time and don't press against the component too hard, or you may fling it out of place. |
| + | [* icon_note] ***Double-check the component orientation*** if it's electrically directional (such as LEDs and diodes). These components normally have a bar indicating the cathode (-) end. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0