crwdns2933803:018crwdne2933803:0
crwdns2933797:0Chayton Rittercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Chayton Ritter
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Use tweezers to grip the component and remove it. |
|---|---|
| + | [* icon_note] If the leads are stuck but don't have a lot of residual solder, heat the solder pad directly and use tweezers or a spudger to gently remove it. |
| + | [* black] If there is still a lot of solder left on the pad, apply more flux and try using the wick again. |
| + | [* black] Use flush cutters to remove your used wick. |
| + | [* icon_reminder] When you're done desoldering, refer to [guide|173873|this step|stepid=371193] to clean up your board. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0