crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Andrew Bookholtcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Insert the small iPod opening tool into the right side of the iPod, with the edge of the tool pointing towards the metal back.
-[* black] Gently enlarge the existing crevice by wiggling the small iPod opening tool and moving it to the left.
-[* black] Continue doing so until the entire side of the iPod is loose.
+[* black] Insert a small iPod opening tool into the seam on the headphone jack edge of the Nano, with the edge of the tool pointing toward the rear panel.
+[* black] Gently enlarge the existing gap by pressing/wiggling the small iPod opening tool into the gap near each of the the two tabs attached to the rear case, pushing the tabs toward the center of the Nano.
+[* black] Continue doing so, working your way along the edge of the Nano until the entire side is free.