crwdns2933803:07crwdne2933803:0
crwdns2933797:0Ryancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ryan
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Using a heat gun, apply heat to the front of the screen for 3-5 minutes to release the glue. |
|---|---|
| + | [* black] Using pry tools, pull back on the plastic blue tabs to release the digitizer and pry it back from the screen. |
| + | [* black] Remove the black trim the lines perimeter of the screen and is attached to the digitizer. |
| + | [* icon_note] This step will be very easy if a the heat gun that was mentioned previously is used. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0