crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0aarondcollegecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 aarondcollege

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Detach the two 3.4mm screws that is holding down the back of the card with a Phillips PH0 screwdriver.
- [* black] The card is spring loaded at the receptacle. If you are holding it down, the card will jump up once both screws are dissemble.
+ [* icon_note] The card is spring loaded at the receptacle. If you are holding it down, the card will jump up once both screws are dissemble.
[* black] Allow the card to raise up, and then slightly push it out of the black receptacle.
-[* black] As you are putting the card back in, make sure it is fully placed in the receptacle before pushing it back down to place in the screws.
+ [* icon_note] As you are putting the card back in, make sure it is fully placed in the receptacle before pushing it back down to place in the screws.