crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Kalynn Copeharvecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kalynn Copeharve

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Apply heat to the heatshrink by moving the hair dryer back and forth over the entire length of the heatshrink until the adhesive is fully stuck to the wire
-[* black] If the size of heatshrink you are using is too large, and it is not sticking to the wire immediately, continue to heat the heatshrink until it sticjs to the entire wire, or consider getting a smaller size of heatshrink
+[* black] Apply heat to the heatshrink.
+[* black] While heating, keep the hairy dryer in motion. Applying heat for too long in one location will result in overheating. Overheating may further damage the frayed or exposed wire underneath, and it can even melt the heat shrink itself.