crwdns2933803:07crwdne2933803:0
crwdns2933797:0Nick Hallcrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Sam Goldheart
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the following screws securing the logic board to the case: | |
| [* red] One 2.5 mm Phillips screw near the vibrator motor | |
| - | [* orange] |
| + | [* orange] screw was taken out before hand |
| [* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening. | |
| [* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff. |