crwdns2933803:02crwdne2933803:0
crwdns2933797:0Phillip Takahashicrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger |
|---|---|
| + | [* black] Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case. |
| + | [* black] If the adhesive is very difficult to separate, reheat the rear panel and try again. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0