crwdns2933803:01crwdne2933803:0
crwdns2933797:0Keaton Frahmanncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Keaton Frahmann
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Remove the external connector from its housing by lifting it up, then out. |
|---|---|
| + | [* black] Next lift the internal power supply brick out of the device. |
| + | [* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down. |
| + | [* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out. |
| + | [* yellow] Disconnect the final power cable from the logic board and be careful to push in the tab on the logic board connector to release the cable lock. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0