crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Alex Ziemanncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Ziemann

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Locate the 1 cm screw situated on top of the plastic hydrofoil wing and the foam outrigger
-[* black] Unscrew this screw using the T8 screwdriver fitting
-[* black] The outrigger should become detached from the plastic wing, and can be separated from the plastic support below
+[* black] Place the drone so that the nose of the boat is pointing to the right
+[* red] Unscrew the 1 cm screw on the end of the plastic arm using the T8 screwdriver fitting
+[* black] Remove the outrigger from the plastic arm