crwdns2933803:02crwdne2933803:0
crwdns2933797:0niccotagliacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 niccotaglia
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the main board and vibration motors. |
|---|---|
| + | [* red] First, unplug the battery connector |
| + | [* blue] Then, undo the 8 clips that hold the board to the front casing with the flathead driver. |
| + | [* icon_note] For the lower clips, you might need a slightly bigger flathead. |
| + | [* black] After that, just lift the board up. |
| + | [* icon_caution] Be careful not to break the wires that go to the vibration motors, as they are soldered to the board. |
| + | [* black] To remove the vibration motors, just pull them out, being careful not to break the wires. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0