crwdns2933803:034crwdne2933803:0
crwdns2933797:0Phillip Takahashicrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Give the beads a few seconds to cool and then remove them and mash them together. |
|---|---|
| + | [* icon_caution] The beads should be fairly warm still, but their container will likely be extremely hot. Use care when removing and handling the beads. |
| + | [* black] Stretch glob of plastic into a thin strip that will fill one of the gaps between the case halves. |
| + | [* black] Press the plastic into the crevices and smooth it out with your finger. |
| + | [* black] If the plastic becomes too hard to work with, you can re-apply heat to loosen the plastic. |
| + | [* icon_caution] Be cautious if you reheat the plastic while it's in the case. Allow cooling periods between reheating so you don't accidentally de-solder any components. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0