crwdns2933803:030crwdne2933803:0
crwdns2933797:0Phillip Takahashicrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Secure the PCB to the upper case half using the original screw and the included washer. |
|---|---|
| + | [* black] Secure the PCB to the upper case half using the original 5.38 mm #1 Phillips screw and the included washer. |
| [* icon_caution] Do not over-tighten the screw or you will break the screw hole. | |
| [* icon_note] Be sure to orient the PCB so that the voltage regulator points towards where the grey power inlet used to be. | |
| [* black] Peel the backing off the heat sink. | |
| [* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is set so that it lines up with the inside edge of the voltage regulator as seen in the third picture. |