crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Knutcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Follow step 1-6 of this guide.[guide|4758]
-[* black] This will enable the logic board just where you need it.
-[* black] If you are uncertain if the EM10 is broken, measure the two sides to see if the are connected. If everything is OK you should have about 0 Ohm both between the two cyan marked solderings and between the two yellow ones. You should NOT have connection between cyan and yellow.
+[* black] This will leave the logic board just where you need it.
+[* black] If you are uncertain if the EM10 is broken, measure the two sides to see if the are connected. If everything is OK you should have about 0 Ohm both between the two cyan marked solderings and between the two yellow ones. You should NOT have connection between cyan and yellow. If you have no connection on either sides you will have to fix it.