crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Sean Huxleycrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Heat the glue to loosen the bond then wiggle the speaker out and use the screwdriver to scrape off the remaining glue.
-[* icon_note] The best way to heat the glue is using a hair dryer on a low setting.
+[* black] Heat the glue to loosen it, then wiggle the speaker up and out. Use the screwdriver to scrape off the remaining glue.
+[* icon_note] An easy way to heat the glue is by using a hair dryer on a low setting.
[* icon_caution] When heating the glue, do not use any high wattage device! This may burn or damage the chips or circuit board.