crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Xin Chencrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Lift the Paper Support. Open the Printer Cover and Front cover.
-[* black] Using the Phillips Screw Driver No.2, remove the following screws that hold the Upper Housing in place: four C.B.P. 3x10 screws, three C.B.S. 3x6 screws, and two C.B.P. 3x10 screws
+[* black] Using the Phillips Screw Driver, remove the 9 screws that hold the Upper Housing in place.
[* black] *Disconnect the Panel FFC and CD-R Sensor Cable from connectors CN1 and CN2 on the Switch Board, and release the CD-R Sensor Cable from the tabs of the Upper Housing.
[* black] *Remove the Guide Pins from the two tabs shown in Figure 4-12, and remove the Upper Housing upwards.