crwdns2933803:01crwdne2933803:0
crwdns2933797:0Gargi Hazracrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gargi Hazra
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Turn the lens/flash assembly 90 degrees, until you can see two screws. |
|---|---|
| - | [* red] Remove the two Phillips #00 screws, being careful not to strip or ruin the screws, with the appropriate screwdriver (Phillips #00) |
| - | [* icon_caution] Be careful you don't strip or ruin the screws, you'll need them to re-assemble the camera properly! |
| - | [* red] Flip the flash up so you can access the other two screws. Remove them too. |
| - | [* icon_note] Be careful not to lose any screws as you will need them to reassemble the camera. |
| + | [* black] Turn the lens/flash assembly 90 degrees, until you see the two Phillips #00 screws. |
| + | [* icon_note] Refer to the image to locate the two screws. The screws are highlighted in red. |
| + | [* black] Remove the two screws with a Phillips #00 screwdriver. |
| + | [* black] Now, flip the flash so that you can access the remaining two screws. Remove these screws following the same procedure as before. |
| + | [* icon_note] Refer to the second image to locate the second set of screws. Again, the relevant screws are highlighted in red. |
| + | [* icon_caution] Be careful while removing the screws. Do not strip or ruin the screws. You will need them to reassemble the camera properly. |