crwdns2933423:0crwdne2933423:0

crwdns2933803:017crwdne2933803:0

crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] To connect the new hard drive, we need to modify some cables.
[* black] The hard drive has a standard 15 pin SATA power connection, but the logic board has a 6 pin slim SATA power connection. A cable to connect them doesn't exist (yet), so we're going to make one.
[* black] The two cables you need are:
[* black] 15 pin ***Female*** SATA power to 4 pin Male Molex power.
[* black] 13 pin ***Male*** Slimline SATA to 7 pin ***Female*** SATA / 4 pin Male Molex power.
[* icon_note] We tried a Molex adapter to connect the two (male) power cables together. However, the bulky Molex connectors are difficult to fit inside the mini.
-[* black] Cut the white Molex connectors off both cables. The excess cable has to fit inside the Mini, so just leave 3-4" on each cable.
+[* black] Cut the white Molex connectors off both cables. The excess cable has to fit inside the mini, so just leave 3-4" on each cable.