crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0oldturkey03crwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] You should now be looking at the PCB's The power board is the one that has the switch on it, as well as two heatsinks.
[* black] Remove the wiring harness on the top right side.
[* black] Remove the connector from the inverter board, as well as the ground wire.
[* black] Remove the green cable from the power board to the housing.
[* black] Remove the connector from the top right and top side. They will only fit one way. No reason to mark the location.
-[* black] Remove the two heatsinks now or later. It does not matter but is personal preference.
+[* black] The two heatsinks can be removed either now or later.