crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Andrew Bookholtcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* icon_note] Support the display with one hand as you remove the remaining T8 screws.
-[* red] Remove the four T8 Torx screws from each side of the display.
+[* red] Remove the two T8 Torx screws from each side of the display (four screws total).
[* icon_reminder] When replacing the display, make sure that the correct screw pins down the ground loop from the display data cable.
[* black] Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles), as well as the display cable (wide connector right hand upper corner) and the cable on top left corner of the logic board.