crwdns2933803:02crwdne2933803:0
crwdns2933797:0Aaron Kondzielacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Aaron Kondziela
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove LED PCB |
|---|---|
| + | [* black] Removing the diffuser exposes the LED PCB. The edge of the WiFi board can also be seen with the antenna protruding. |
| + | [* black] On the LED PCB, you can see the white and colored LEDs. The PCB is a thermally-conductive aluminum material. |
| + | [* black] Around the edge of the bulb's case there is a plastic retaining ring attached by four Phillips-head screws. It's not necessary to remove this for further disassembly. |
| + | [* black] The LED PCB has a pin header that connects down into the WiFi board. A thermal adhesive pad holds the PCB to the metal bulb case. You can gently pry around the edge of the PCB until the adhesive releases, and the connector separates. |
| + | [* black] On my bulb, the PCB was not fully-seated on the thermal pad, potentially causing heat-related intermittent faults. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0