crwdns2933803:020crwdne2933803:0
crwdns2933797:0Evan Noronhacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Evan Noronha
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Heat an iOpener and lay it over the logic board on the rear case. |
|---|---|
| + | [* black] Wait a couple minutes for the adhesive to soften, then flip the iPad over and pivot the opening pick at the lower edge around the bottom left corner of the logic board. |
| + | [* icon_caution] Be very careful to not sever the battery connector with the pick. Hold the pick at an angle to the rear case and push the connector down to be safe. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0