crwdns2933803:01crwdne2933803:0
crwdns2933797:0Sam Goldheartcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Goldheart
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Reheat your iOpener. | |
| [* black] Lay the iPad face down on your work surface and place the iOpener on the rear case, where the lower edge of the battery is. | |
| - | [* icon_note] Wait about two minutes before moving on to the next step to ensure the battery adhesive is adequately softened. |
| + | [* black] Wait about two minutes before moving on to the next step to ensure the adhesive holding the battery to the rear case is adequately softened. |
| + | [* icon_note] In the following steps you will be cutting the adhesive under the battery, and prying it off of the rear case. To avoid battery damage, do not puncture, bend, or overheat the battery. |
| + | [* icon_caution] Do not pry agains the logic board or you could damage your iPad. |