crwdns2933803:02crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_caution] Before you start placing strips, remove all of the old adhesive around the perimeter of the rear enclosure. | |
| [* black] If you are re-using your existing display, you must also remove the old adhesive from the back of the display. | |
| - | [* black] Use a pair of tweezers to grasp and peel up |
| + | [* black] Use a pair of tweezers to grasp and peel up each strip of adhesive—or if necessary, use a spudger to scrape up the adhesive, and peel with your fingers. |
| [* icon_reminder] Repeat this process as necessary to remove all of the old adhesive. | |
| - | [* icon_note] If necessary, use a spudger to scrape up the remaining adhesive, then peel with your fingers. |
| + | [* black] For best results, after all the adhesive is removed, carefully clean the area under the adhesive with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth. |
| + | [* black] This helps prep the surface so that the new adhesive bonds properly (and your display won't fall out). |