crwdns2933803:01crwdne2933803:0
crwdns2933797:0Geoff Wackercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Geoff Wacker
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Measure a length of heat shrink tubing to cover the damaged section of wire. | |
| [* icon_note] The heat shrink tubing will slightly shrink longitudinally, so be sure to give yourself a little longer than what you measured. | |
| [* black] Measure the diameter of the wire, and then choose a heat shrink diameter that will be large enough to slide onto the wire before heating, but will still provide a snug fit once heated. The shrunken diameter should be slightly smaller than the wire's diameter to ensure a tight fit. | |
| - | [* icon_note] Most tubing has a shrink ratio that dictates how much the tubing will shrink once heated. For example, a length of 2:1 ratio tubing with a diameter of |
| + | [* icon_note] Most tubing has a shrink ratio that dictates how much the tubing will shrink once heated. For example, a length of 2:1 ratio tubing with a diameter of 4 cm will shrink to a diameter of 2 cm. |
| [* icon_note] If the wire has a connector end that is larger than the diameter of the wire, you'll need to choose tubing that can fit over the connector, and then shrink down enough to fit snugly on the wire (A higher shrink ratio will be needed). | |
| [* black] Use a pair of scissors to cut the heat shrink tubing to the appropriate size. |