crwdns2933803:013crwdne2933803:0
crwdns2933797:0Kelsea Webercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kelsea Weber
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Reinstall the Gear / Burr holder assembly | |
| [* black] With the following pieces aligned carefully set the gear assembly into place: | |
| [* red] Avoid rotating these pieces to maintain alignment. | |
| [* orange] As you set the assembly into place, make sure the two stop-screws are on the left side of the black plastic stop. | |
| [* yellow] Align the large peg with the wide slot. | |
| [* green] Align and the small peg with the small slot. | |
| [* black] Press down on the gear assembly to snap it into place. | |
| [* black] Once in place, rotate the coarseness knob through the full range to make sure it's all working. | |
| - | [* |
| + | [* icon_note] Watch the reinstallation video [https://youtu.be/1lL8BInrki8?t=15m41s|here] for clarification. |