crwdns2933803:08crwdne2933803:0
crwdns2933797:0Ben Gottemollercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben Gottemoller
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Gear / Burr holder Assembly Removal | |
| [* black] Pay close attention to the pic here. The big white gear assembly pops right off with a little upward pressure. It's critical that the alignment be preserved though. | |
| + | [* black] Tip: Using a permanent marker, you can make a dot on each of the pieces pointed to by arrows. These make nice alignment reference marks in case the pieces do accidentally get rotated. The dots should stay lined up. |
| [* black] FYI: The small gear in the picture is an encoder. Its purpose is to track the position of the grind adjustment level so it can be displayed on the digital readout. If it gets out of alignment the display will end up reading wrong. |