crwdns2933803:02crwdne2933803:0
crwdns2933797:0Philip Zietkowskicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Philip Zietkowski
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] In order to remove the magnetic pen, you must desolder the two wires connecting it to the circuit board. | |
| [* black] When you desolder, apply the tip of the soldering iron to the soldered joint for approximately 5 - 10 seconds. | |
| [* black] The soldered joint will turn to a liquid consistency. At this moment, remove the wire and soldering iron. | |
| - | [* black] Repeat each of the following steps for the second soldered joint. |
| + | [* black] Repeat each of the following steps for the second soldered joint. (remove bullet?) |
| [* icon_caution] Soldering irons are dangerously hot. The soldering iron should only come in contact with joints being desoldered or soldered. | |
| [* icon_note] Make sure to allow time for your soldering iron to heat up before using it. | |
| [* icon_note] Make sure the tip of the soldering iron is cleaned so the tin on the tip is exposed. This will allow the soldering iron to work efficiently. |