crwdns2933803:02crwdne2933803:0
crwdns2933797:0Daniel Quilliamcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Daniel Quilliam
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] The first part of this step is to remove the hot glue from the base of the wires using the plastic opening tool. |
|---|---|
| + | [* red] once the hot glue has been taken off you just have to desolder the two wires from the board. |
| + | [* icon_note] The ribbon cable connected to the writing surface should pop off he board easily, no soldering required! |
| + | [* icon_caution] Soldering irons and solder get very hot, ensure you are following proper procedure when desoldering the wires. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0