crwdns2933805:0crwdne2933805:0
crwdns2933797:0jpfoxracing9crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 jpfoxracing9
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Once the sander is completely open and you can see both the fan and spinning circle, line up your new pad, tighten, and apply new sandpaper. Be sure your sander pad is tight so you do not get an uneven sand on your surfaces. |
|---|---|
| + | [* black] Once the sander is completely open and you can see both the fan and spinning circle, line up your new pad with the holes on the bottom of the sander. |
| + | [* black] Once aligned find your screw driver and tighten the three screws as tight as possible to avoid uneven surface sanding. Once you cannot tighten them further the device is ready to use again. |
| + | [* black] Apply a new sandpaper onto your new pad and begin sanding as needed. |