crwdns2933423:0crwdne2933423:0

crwdns2933803:08crwdne2933803:0

crwdns2933797:0Ron Daviscrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ron Davis

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Position a wire to the corresponding connection point on the jack.
[* black] Carefully apply a small amount of solder to hold the wire in place.
[* black] Repeat this for each wire.
[* icon_reminder] Make sure to reference the mapping of wires to connection points that you created in Step 4.
[* icon_note] When soldering the wires, be patient and meticulous about getting the right position to make a good connection.
-[* icon_note] If the internal wires do not have their own insulation, use a small bit of shrink tube on each wire. This will prevent them from shorting across another wire.
+[* icon_note] If the internal wires do not have their own insulation, use a small bit of shrink tubing on each wire. This will prevent them from shorting across another wire.