crwdns2933803:01crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_note] There is adhesive holding the back plate in place. Be careful removing this as there is wiring on the other side. | |
| - | [* red] Using the sim card removal tool, pry off the back plate. |
| + | [* red] Insert the SIM card removal tool or the point of a spudger into the tiny notch in the frame near the SIM card tray, and pry up. |
| + | [* icon_note] This will allow you to open a slight gap behind the back panel. |
| + | [* black] Insert an opening pick or other plastic tool into the gap and slide it around the entire perimeter of the phone to release the adhesive and remove the back plate. |
| + | [* icon_note] If the adhesive is too tough, use an iOpener or hair dryer to heat the back of the phone and soften the adhesive, and try again. |