crwdns2933803:04crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Place the leads of the resistor through the holes on either side of the rectangle marked ***R1*** on the circuit board. | |
| [* icon_note] Resistors do not have to be installed in a particular orientation. Either lead can go into either hole. | |
| - | [* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture |
| + | [* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture. |
| [* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable. |