crwdns2936039:0Electronics Skills Kit 101crwdnd2936039:04crwdne2936039:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0David Hodsoncrwdnd2933797:0Mha 5, 2011crwdne2933797:0

	[* black] Place the leads of the resistor through the holes on either side of the rectangle marked *R1* on the circuit board.
	[* icon_note] It does not matter which end faces which way when installing resistors.
	[* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air.
-	[* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to ~~30^^o^^~~ down from vertical is acceptable.
+	[* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable.