crwdns2933803:06crwdne2933803:0
crwdns2933797:0Brucecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bruce
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the failed rear wheel switch unit | |
| [* black] Refer to section ''8.3.10 Removal of the Flash P.C.B.'' of the Service Manual. Only the portion of ''Fig. D14'' dealing with replacing the switch unit is applicable to this repair - there is no need to dissipate the E.Capacitor or remove the Flash P.C.B. | |
| - | [* black] With the Top Unit removed, you gain access to the rear wheel switch itself. Start |
| + | [* black] With the Top Unit removed, you gain access to the rear wheel switch itself. Start by removing the two top screws on either side of the wheel. |
| [* black] Next, pry the wheel assembly from its mount using a small, flathead screwdriver on either side. | |
| [* black] Flip the switch over and disconnect its ribbon cable. |