crwdns2933803:02crwdne2933803:0
crwdns2933797:0Brucecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bruce
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Separating the front and rear halves |
|---|---|
| + | [* black] Refer to section ''8.3.1 Removal of the Rear Case Unit'' of the Service Manual. |
| + | [* black] To replace the rear wheel switch, you'll have to split the camera into its front and rear halves. Before you remove any screws, remove the battery and storage card. |
| + | [* black] Use a small, flat screwdriver to pry out and remove the hot shoe spring. This allows access to screws beneath the hot shoe. |
| + | [* black] Remove the two ***black ***screws as indicated. Leave the silver screws in place. |
| + | [* black] Remove the following screws around the body of the camera: 2 bottom screws (on rear half), 2 right-side screws, 1 screw on left-hand side. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0