crwdns2933803:03crwdne2933803:0
crwdns2933797:0David Hodsoncrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_note] This step is for removing the brake drum and the wheel bearing together. | |
| - | [* black] Use a |
| + | [* black] Use a mallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap. |
| [* black] Pry the dust cap out of the brake drum with the flat head screwdriver. | |
| [* red] Remove the 29 mm rear hub bolt nut from the brake drum. This will require either a breaker bar or an impact wrench. | |
| [* icon_note] This nut is torqued to 175 ft-lbs, and should not be removed more than four times. Use a permanent marker to make a mark on the nut each time it is removed. |