crwdns2933803:03crwdne2933803:0
crwdns2933797:0David Hodsoncrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_note] This step is for removing the brake drum and the wheel bearing together. |
|---|---|
| + | [* black] Use a hammer and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap. |
| + | [* black] Pry the dust cap out of the brake drum with the flat head screwdriver. |
| + | [* red] Remove the 29 mm rear hub bolt nut from the brake drum. This will require either a breaker bar or an impact wrench. |
| + | [* icon_note] This nut is torqued to 175 ft-lbs, and should not be removed more than four times. Use a permanent marker to make a mark on the nut each time it is removed. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0